Aerco Adding a Communications Board to ECS Manual de usuario descargar pdf (Pagina 1)

2006-03

May 30, 2006

INTERNATIONAL, INC.

159 PARIS AVENUE • NORTHVALE, NJ 07647 • PHONE 201-768-2400

PROCEDURE FOR ADDING A COMMUNICATIONS BOARD TO

ECS TEMPERATURE CONTROLLER

Parts Needed:

a. Control Box Assembly ECS, P/N: 69012-[ ]

b. Temperature Indicating Controller, P/N: 64008

c. Communications Board, P/N: 64009-[ ]

Procedure:

1. Turn off power to Control Box Assembly ECS (P/N 69012-[ ])

2. Slide out Temperature Indicating Controller (P/N: 64008) from Control Box Assembly

by gently pushing the indicated latching ears to the side (See Figure 1)

Figure 1

3. Slide Communications Board (P/N 64009-[ ]) into Temperature Indicating Controller

slot (COMMS 1). See Figure 2. Make sure to push Communications Board all the

way in to ensure it is firmly seated in its slot.

Figure 2

COMMUNICATIONS

BOARD

LATCHING

EARS

(

)

1 2 3 4

2006-03 May 30, 2006 1INTERNATIONAL, INC. 159 PARIS AVENUE • NORTHVALE, NJ 07647 • PHONE 201-768-2400 PROCEDURE FOR ADDING A COMMUNICATIONS BOARD

2 4. Place Temperature Indicating Controller back into Control Box Assembly and power up unit. The following screen will appear. (See Figure 3)

3MODBUS COMMUNICATIONS WIRING CONNECTIONS Following installation of the Communications Board, wiring connections must be made on the rear of the 240

4NOTE AERCO recommends that shielded, twisted-pair cable be used for communication wiring. Examples of suitable wiring are : Belden 9841, 8761, 3105

Sin comentarios

Aerco Adding a Communications Board to ECS Manual de usuario Pagina 1