
E8 Controller and BCM for Modulex EXT
Installation, Operation & Maintenance Manual
CHAPTER 3: E8 CONTROLLER OPERATION
Page 16 of 108 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0093_0A
PRI: 06/24/2013 Phone: 800-526-0288 GF-136-C
3.2.2 Basic Parameter Navigation, Selection, and Revision
When in the USER, TIME PROGRAM, EXPERT, or GENERAL Main Menu, virtually all sub-
menu items can be changed if the desired. Perform the following steps to access, view, and/or
change menu item parameters:
PARAMETER CHANGE PROCEDURE
Use Rotary Knob to navigate to desired Menu/Sub-
menu. Menu and sub-menu are indicated by two small
black arrows at bottom of LCD display pointing down to
menu/sub-menu names below display (see Figure 3-4).
Press Program Key to access parameters in the
selected (displayed) sub-menu.
Turn the Rotary Knob to sequence through the
available parameters.
To change a parameter value, press the Program Key
when the desired parameter is displayed. The Change
LED will light up indicating the displayed parameter may
now be changed.
To change the displayed parameter value, turn the
Rotary Knob; clockwise to increase value and counter-
clockwise to decrease the value.
To save the displayed parameter value to the controller
memory, press the Program Key. The Change LED
will turn off indicating the new value has been saved.
HOT
WATER
T
DHW
T
DHW
141.0
142.0
HOT
WATER
parameter
accessed
Value Saved!
Example: User Menu & Hot Water Sub-menu
accessed
parameters
values
142.0
140.0
Comentarios a estos manuales