Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario descargar pdf (Pagina 51)

E8 Controller and BCM for Modulex EXT

Installation, Operation & Maintenance Manual

CHAPTER 5: E8 CONTROLLER MENUS AND SUB-MENUS

OMM-0093_0A AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 51 of 108

GF-136-C Ph.: 800-526-0288 PRI: 06/24/2013

Table 5-7: SERVICE Menu Listing

FUNCTION DESCRIPTION REMARKS

RELAY TEST Sub-Menu

This Sub-Menu is used to check the status of the relays contained in the

Controlller. These relays are numbered 00 through 11 and are defined as shown

below. CODE NO. Entry is required to access these relays.

RELAY NO.

No relay

A1: Pump, Heating Circuit 1

A2: Pump, Heating Circuit 2

A3: Hot Water Charging Pump

A4: Mixer OPEN, Heating Circuit 2

A5: Mixer CLOSED, Heating Circuit 2

A6: HS 1 ON

A7: HS2 ON [2-stage:HS 1+2 (after 10s) ON]

08 A8: Mixer OPEN Heating Circuit 1 /

Multifunction 1

09 A9: Mixer CLOSED Heating Circuit 1 /

Multifunction 2

A10: Multifunction 3

A11: Collector Pump / Multifunction 4

SENSOR TEST Sub-Menu

This Sub-Menu is used to check and display the temperature readings of the

sensors connected to the Controller.

SENSOR

Lower buffer storage temperature

F2 Middle buffer storage temperature or room

temperature heating circuit 1

Upper buffer storage temperature

Flow temperature, heating circuit 2

Upper hot water temperature

Heat generator /header temperature

Outside temperature

SERVICE

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 107 108

Sin comentarios

Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario Pagina 51