Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario descargar pdf (Pagina 58)

E8 Controller and BCM for Modulex EXT

Installation, Operation & Maintenance Manual

CHAPTER 6: E8 SETUP & PROGRAMMING

Page 58 of 108 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0093_0A

PRI: 06/24/2013 Phone: 800-526-0288 GF-136-C

Indoor/Outdoor Reset Configuration in USER Menu

1. Ensure ON/OFF switch on front of Modulex boiler is in the ON position.

2. Open controller front panel.

3. Turn the Rotary Knob clockwise to the USER menu. The first sub-menu displayed will be

INSTALLATION.

NOTE

Before continuing, check to ensure that HC FUNCTION in the

EXPERT>HEATING CIRCUIT 1 menu is set to the default “00”.

4. Continue scrolling clockwise through the USER menu until the HTG CIRCUIT 1 sub-menu

is displayed.

5. With HTG CIRCUIT 1 displayed, press Program Key to enter sub-menu.

6. Use Rotary Knob to scroll to the HEATSLOPE sub-menu item. The display will show

“HEATSLOPE” and the current value stored in memory (0.00 to 3.00).

7. To change the HEATSLOPE value, press the Program Key. The red LED will light.

8. Refer to Heat Slope Diagram (Figure 6-1) to determine the required value for the

HEATSLOPE function based on the boiler installation design set point. The value entered

must be between 0 and 3.00.

9. Turn Rotary Knob until the desired HEATSLOPE value is displayed.

10. Press the Program Key to store the HEATSLOPE value.

11. Continue scrolling through the HTG CIRCUIT 1 sub-menu until RETURN is displayed.

Press the Program Key to exit the HTG CIRCUIT 1 sub-menu.

Figure 6-1: Heat Slope Diagram

100

110

120

130

140

150

160

170

180

190

200

210

220

0510152025303540455055606570

Outside Temperature ( F )

Flow Temperature ( F )

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 107 108

Comentarios a estos manuales

Sin comentarios

Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario Pagina 58

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo