Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario descargar pdf (Pagina 61)

E8 Controller and BCM for Modulex EXT

Installation, Operation & Maintenance Manual

CHAPTER 6: E8 SETUP & PROGRAMMING

OMM-0093_0A AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 61 of 108

GF-136-C Ph.: 800-526-0288 PRI: 06/24/2013

6.2.4.1 Configuring HEATSLOPE Parameter

The HEATSLOPE value is configured as shown in the instructions below.

Configuring HEATSLOPE Parameter

1. Ensure ON/OFF switch on front of Modulex boiler is in the ON position.

2. Open controller front panel.

3. Turn the Rotary Knob clockwise to the USER menu.

4. Press Program Key to select the User submenu. The first item (sub-menu) displayed will be

INSTALLATION.

5. Continue scrolling clockwise through the USER menu until the HTG CIRCUIT 1 sub-menu is

displayed.

6. With HTG CIRCUIT 1 displayed, press the Program Key to enter this sub-menu.

7. Using the Rotary Knob, scroll to the HEATSLOPE variable. The display will show

“HEATSLOPE” and the current value stored in memory (0.00 to 3.00).

8. If the desired value for HEATSLOPE is not displayed, press the Program Key once. The red

LED will light.

9. Determine the required value for the HEATSLOPE function as explained above. The value

to be entered must be between 0 and 3.00 inclusively.

10. Turn the Rotary Knob until the desired HEATSLOPE value is displayed.

11. Press the Program Key to store the HEATSLOPE value. The value will flash indicating it

was entered.

12. Continue scrolling through the HTG CIRCUIT 1 sub-menu until RETURN is displayed. Press

the Program Key to exit the HTG CIRCUIT 1 sub-menu.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 107 108

Sin comentarios

Aerco Modulex E8 Controller (and BCM) For Modulex EXT Bo Manual de usuario Pagina 61