Aerco ProtoNode Gateway Rev 3 (with external LEDs) Manual de usuario descargar pdf (Pagina 28)

AERCO ProtoNode Gateway

User Manual

Page 28 of 126 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0080_0H

11/06/2014 Ph.: 800-526-0288 GF-129

CHAPTER 5: Connect the ProtoNode’s Web GUI to Setup IP

Address for BACnet/IP*

*Available on ProtoNode Units with External LEDs, otherwise use the RUINET utility (section 6)

5.1 Connect the PC to the ProtoNode via the Ethernet Port

Figure 5-1: Ethernet port location of ProtoNode

1) Connect a standard CAT5 Ethernet cable (straight through or cross) between the PC

and ProtoNode.

2) The Default IP Address of the ProtoNode is 192.168.1.24, Subnet Mask is

255.255.255.0. If the PC and the ProtoNode are on different IP Networks, assign a static

IP Address to the PC on the 192.168.1.xxx network.

3) Go to:

> >

4) Right-click on: Local Area Connection > Properties

5) Highlight:

6) Select: Use the following IP address (as shown below)

7) Click: twice.

10/100 Base T

Ethernet

Connector

ProtoNode LER

ProtoNode RER

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 125 126

Sin comentarios

Aerco ProtoNode Gateway Rev 3 (with external LEDs) Manual de usuario Pagina 28